Handmade patchwork quilting process

  As we all know, with the industrial technology of intelligent development, industrial products production increase quickly, and the quality is be obvious to people, cause now handmade products price is very expensive, although expensive, but the handmade products are still scarce.Below we say handmade patchwork quilting, have a look what are the advantages of it.Quilting is designed to be a "quilt sandwich" three layers together, and beautiful quilting patterns for patchwork works also play a role in.Quilting can be divided into manual quilting and quilting quilting, relative to the quilting machine, hand quilting quilting is soft, feel better.

1 first determines the first needle position and quilted direction, the following diagram, determine the first needle position, quilted direction is top-down, and then at a distance from the first pin down 5 centimeters place into the needle, needle through the dissection (auxiliary cotton layer), but do not wear the bottom layer, and from the first needle position out of the needle, a needle pulling thread after, when the line is pulled into the needle knot, slightly increase strength let line node through the surface, such as the hidden nodes, lines, both in the patchwork of positive and negative are invisible thread.

2 now officially start quilting, quilting using small needle distance running stitch (Running stitch), based on the length of the needle entry (as shown below), then send thread tension.Hand needle must pass through all the layers, therefore, when the general right hand quilting needle in the quilt surface work, and his left hand on the back of the quilt with fingertips (generally for the middle finger) to feel tip is in the bottom layer, and then guide the needle tip in the back into the needle position made it again to wear surface.

Need needle extraction, can be used in the needle tail drive thimble.3 in the image above, the needle is attached to the front row that quilt, quilted out the effect of positive needle distance ratio (bottom) back stitch length; in addition, you can also let the hand needle vertical access (as shown below), this kind of positive and negative after quilting needle distance is long:

4 when the needle on the line about to run out of time, at a distance from the last needle ca. 5 cm length line knot, and then move into a needle from the needle, the needle through the dissection (don"t wear to the rear):

Hand stitches from the sandwich layer back in, at a distance of about 6 cm, the needle quilting path deviation of about 1.5 cm from the needle, and then pulling thread, let the line node through the surface is hidden; again with a distance of 5 cm to the line knot, after a needle into the needle from: Note: white dotted line line in the interlayer position.

From the dissection in return a equal distance, repeat the above steps, a needle sticking a quilt surface will end after the cut:

5 back in line, you just repeat step 1, hide the good head, continue to start quilting:
 originally interrupt

Summary of key points:

1 hide head and tail; the 2 thread through all layers.

News source: HengYeJiXie